case the message is too long to fit on a single physical line and has to
be wrapped, the source location won't be emitted (as prefix) again,
over and over, in subsequent continuation lines. This is the default
-behaviour.
+behavior.
@item -fdiagnostics-show-location=every-line
Only meaningful in line-wrapping mode. Instructs the diagnostic
understands but would ignore because the @samp{#} does not appear as the
first character on the line. It also suggests you hide directives like
@samp{#pragma} not understood by traditional C by indenting them. Some
-traditional implementations would not recognise @samp{#elif}, so it
+traditional implementations would not recognize @samp{#elif}, so it
suggests avoiding it altogether.
@item
version of a program there is often substantial code which checks
correct functioning of the program and is, hopefully, unreachable
because the program does work. Another common use of unreachable
-code is to provide behaviour which is selectable at compile-time.
+code is to provide behavior which is selectable at compile-time.
@item -Winline
@opindex Winline
constants) accross compilation units.
This option is default for optimized compilation if assembler and linker
-support it. Use @option{-fno-merge-constants} to inhibit this behaviour.
+support it. Use @option{-fno-merge-constants} to inhibit this behavior.
@item -fmerge-all-constants
Attempt to merge identical constants and identical variables.
arrays or initialized constant variables with integral or floating point
types. Languages like C or C++ require each non-automatic variable to
have distinct location, so using this option will result in non-conforming
-behaviour.
+behavior.
@item -fno-function-cse
@opindex fno-function-cse
sequence of other programs to do the work of compiling, assembling and
linking. GCC interprets its command-line parameters and uses these to
deduce which programs it should invoke, and which command-line options
-it ought to place on their command lines. This behaviour is controlled
+it ought to place on their command lines. This behavior is controlled
by @dfn{spec strings}. In most cases there is one spec string for each
program that GCC can invoke, but a few programs have multiple spec
-strings to control their behaviour. The spec strings built into GCC can
+strings to control their behavior. The spec strings built into GCC can
be overridden by using the @option{-specs=} command-line switch to specify
a spec file.
@itemx -msupersparc
@opindex mcypress
@opindex msupersparc
-These two options select the processor for which the code is optimised.
+These two options select the processor for which the code is optimized.
With @option{-mcypress} (the default), the compiler optimizes code for the
Cypress CY7C602 chip, as used in the SparcStation/SparcServer 3xx series.
turned into long calls.
This feature is not enabled by default. Specifying
-@option{-mno-long-calls} will restore the default behaviour, as will
+@option{-mno-long-calls} will restore the default behavior, as will
placing the function calls within the scope of a @samp{#pragma
long_calls_off} directive. Note these switches have no effect on how
the compiler generates code to handle function calls via function
@opindex msingle-pic-base
Treat the register used for PIC addressing as read-only, rather than
loading it in the prologue for each function. The run-time system is
-responsible for initialising this register with an appropriate value
+responsible for initializing this register with an appropriate value
before execution begins.
@item -mpic-register=@var{reg}
OSDN Git Service
